Catalog
Features:
Silicon Features
Internal design provides a positive seal while the wide flange allows for easy removal. Reusable and will not melt or harden
Industries: Powder coating, E-coating, Plating and Anodizing
EPDM Features
Internal design provides a positive seal while the wide flange allows for easy removal. Excellent chemical resistance and reusable.
Industries: Powder Coating, E-coating, Plating, Anodizing and Sand Blasting, Lower cost alternative to Silicone if higher than 350 ºF (176 ºC) is not needed.
Silicon Features
Internal design provides a positive seal while the wide flange allows for easy removal. Reusable and will not melt or harden
Industries: Powder coating, E-coating, Plating and Anodizing
EPDM Features
Internal design provides a positive seal while the wide flange allows for easy removal. Excellent chemical resistance and reusable.
Industries: Powder Coating, E-coating, Plating, Anodizing and Sand Blasting, Lower cost alternative to Silicone if higher than 350 ºF (176 ºC) is not needed.
Unit of Measure
Specifications
To Assure Proper Fit |
N/A
Silicone Cap inside diameter should be approximately 10 % smaller than the outside diameter of the part. EPDM Cap inside diameter should be approximately 5-7 % smaller than the outside diameter of the part. |
Material |
N/A Silicone |
Color |
N/A Natural |
Temperature |
N/A 600 ºF315 ºC |
Dimension A |
N/A 0.236 in6.000 mm |
Dimension B |
N/A 1.180 in30.000 mm |